Airmon-ng

Description

This script can be used to enable monitor mode on wireless interfaces. It may also be used to go back from monitor mode to managed mode. Entering the airmon-ng command without parameters will show the interfaces status.

Usage

usage: airmon-ng <start|stop|check> <interface> [channel or frequency]

Where:

• <start|stop> indicates if you wish to start or stop the interface. (Mandatory)
• <interface> specifies the interface. (Mandatory)
• [channel] optionally set the card to a specific channel.

例子

~# airmon-ng
PHY    Interface    Driver        Chipset

phy0    wlan0        ath9k_htc    Atheros Communications, Inc. AR9271 802.11n
~# airmon-ng start wlan0
~# airmon-ng stop wlan0mon